Calculation Overhead Crane Double Girder

https://kamarkhani.info/product/calculation-overhead-crane-double-girder/

link copied successfully

Rated 5.00 out of 5 based on 1 customer rating

1 review

CDMC’s crane calculation software solves your need for an accounting engineer. The software also saves your time because by using the crane calculation software, all calculations are done in less than 15 minutes and you have to go to the next stage, i.e. design. The exact weight of the crane is one of the advantages of this software, because you can calculate the total cost in order to participate in tenders and technical proposals to the employer and avoid wasting material.

Category: Calculations

700 $

Demo Software Calculation Overhead Crane Double Girder

Determining the Dimensions of the Girder

One of the most important parts of calculating any type of crane is its Girder. In this software, it has been tried to check the basic parameters of the design in the interface with the Girder. Also, the stress applied to the points of the Girder is evaluated in terms of fatigue. In the other part, choosing the exact dimensions of the Girder helps a lot to prevent waste material. Finally, determine the most optimal state of the Girder based on the working group of the crane.

1
Choosing the exact dimensions of the Girder
2
The exact weight of the Girder to participate in tenders
3
Calculation of Girder camber
4
Calculation of Girder deflection
5
Elastic section modulus
6
Stress Main Girder
7
Fatigue Main Girder
8
Buckling Box Diaphragm

Longitudinal End Carriage calculations

In this software, the calculation of the End Carriage is also discussed. And at the moment you can check the choice of two-wheel or Eight-wheel End Carriage and choose according to your technical requirements and conditions. By choosing the dimensions of the End Carriage box and then calculate the welding stress created in the End Carriage and….

1
Max Deflection End carriage
2
TOTAL COMBINED STRESS
3
Calculation Wheel Base End carriage
4
Selection Box or Tube Fram End Carriage
5
Calculation Wheel Load
6
Calculation Wheel Load

Selection Motors Crane

The choice of engine is of particular importance in the construction of cranes. In this software, you can choose longitudinal, transverse and lifting motors using the working conditions of the crane. Therefore, the effect of the speed of movement in any direction, the working group of the crane, the temperature of the environment and also the type of engines are of particular importance, and you can change the power of the engine in a large range.

1
Selection Motor & Gearbox Hoist
2
Selection Motor & Gearbox Traversing
3
Selection Motor & Gearbox Traveling
4
Selection Power and RPM

Selection Size Rail and wheel

In the double bridge overhead crane designer software, you can determine the length and width of the rails and wheels. The material, number of wheels, wheel load, longitudinal and transverse speed, as well as the working group of the crane are very effective.